AUZ 3 sensor-controlled WC flushing system
AUZ 3 is a sensor-controlled flushing system for lavatories. After leaving the scanning zone, the electromagnetic valve is opened and the flushing system is activated.
The photocell sensor does not react to people passing by, and is not sensitive to daylight and artificial lighting. A manual press button is available when cleaning.
An anchoring distance frame is used to level off any imprecision in setting the casket.
The AUZ 3 automatic flushing system for lavatories is intended for social facilities, where a high standard of hygiene at maximum water savings is required, and it can be used for all types of closets. The most suitable type is a wall-hang closet, set-up on a KZ 1 mounting cantilever. This solution stands out because of its high aesthetic level and allows the toilet to be cleaned. The KZ 1 cantilever needs to be ordered separately.
- Installation casket
- inlet bolting
- outlet pipe
- stainless steel casing with electronics cabinet
- electromagnetic valve
- anchoring distance frame
- covering metal assembly plate
- small assembly materials
KZ 1 – cantilever of wall-hang closet
AUZ 01 – stainless steel closet
|Radius of sensor||self-adjusting|
|Water inlet||G 3/4“|
|Water pressure||0,1 – 1,0 MPa|
|Adjustable time of flushing||0 – 20 sec. (adjusted to 5 sec.)|
|Power supply||12 V, 50 Hz|
|Power requirement||6 VA|
|Source of power supply||ZAC 1/20 (max. 3 x AUZ 3)|
|ZAC 1/50 (max. 8 x AUZ 3)|
- Set-up water supply with a minimum water flow of 70 l/min as per picture (with a filter)
- Set-up alcove 150x150x100 mm for installation casket
- Set-up cable for power supply – 12 V, 50 Hz from source of power supply ZAC
- Set-up water supply to toilet bowl - pipe d = 34 mm
- A –
water inlet inner pipe G 3/4". G 1"
- C –
electricity supply Cabel CYKY 2Ax1,5
- D –
- E –
zone of scaning
- F –
- G –
water inlet into closet piped d = 34 mm
- * –
as per type of closet