AUZ 5 automatic flushing system for WCs, wall module
AUZ 5 is an automatic flushing system for WCs concealed in a wall toilet module with an automatic flushing system and chrome-plated cover. The system is designed for wall-hang closets with inlet and outlet spacing of 135 mm and with spacing of anchoring screws of either 180 or 230 mm.
A photocell sensor reacts after a person leaves the room containing the toilet and activates the servo-drive of the flush that starts working afterwards. The flushing option between 1/1 or 1/2 of cistern is retained. After 24 hours inactivity the urinal flushes itself.
Construction of the cantilever assures the spread of the load to floor and wall. This allows the fixing of the wall-hang closet to walls with a lower load capacity. A maximum depth of 150 mm is sufficient to anchor the urinal.
An AUZ 5 cantilever is suitable for its application into plaster slabs and is intended for social facilities, where the user´s comfort and a high standard of hygiene at maximum water savings is required.
- on-wall module system
- stainless steel metal plate with built-in electronics
- power part of the electronics
- mechanical connection
- small assembly materials
|Radius of sensor||self-adjusting|
|Water inlet||G 1/2"|
|Water pressure||0,1 – 1,0 MPa|
|Outlet||d = 110 mm|
|Power supply||12 V, 50 Hz|
|Power requirements||resting state 1 VA|
|when open 40 VA|
|Source of power supply||ZAC 1/50|
- Set-up cable for power supply – 12 V, 50 Hz from source of power supply ZAC
- Set-up drainage d = 110 mm
- Set-up water inlet, pipe 1/2“ – as per picture
- A –
water inlet G 1/2"
- C –
electricity supply Cabel CYKY 2Ax1,5
- D –
outlet d = 110 mm
- E –
zone of scaning